2.8 inch tft lcd display touch screen arduino brands

But I"ve been happily surprised. Everything works smoothly, and the touchscreen is accurate in reading points across the entire surface. (There is NO calibration issue as you control the offset in code yourself)

The card - being a shield - means you can just line up the pins on the board to the mount holes on the Arduino, and the card pushes firmly into place.

The build quality is excellent - the surface mount chips are all soldered well, the display is mounted cleanly on the PCB. You even get a little plastic stylus for the capacitive touchscreen.

Warning! You might need to power your Arduino board along with the USB power. I found my little laptop couldn"t power the bright white screen LED"s, RGB screen, and Arduino all at the same time. The Arduino would repeatedly "unplug", and then "replug".

The 2.8 inch TFT LCD Touch Display is fully assembled, tested and ready to go. Add the touch display without wiring, no soldering! Simply plug it in and load up a library – you’ll have it running in under 10 minutes! Works best with any classic Arduino ATMEGA328 Board. So spice up your Arduino UNO project with a beautiful large touchscreen display shield with a built-in microSD card connection. This TFT display is big (2.8″ diagonal) bright (4 white-LED backlights) and colorful (18-bit 262,000 different shades). The Display comes with 240×320 pixels with individual pixel control. It has way more resolution than a black and white 128×64 display. As a bonus, this display has a resistive touchscreen attached to it already, so you can detect finger presses anywhere on the screen.