ebike s866 lcd display settings parameters in stock

Note: The value here is based on kilometers. When the unit setting is converted from kilometers to miles, the speed value on the display interface will be automatically converted to the correct mile value, but the speed limit value data set in this menu under the mile interface No conversion, it is inconsistent with the actual displayed mile speed limit value;

Note: Due to the upgrade of the company"s products, the displayed content of the product you get may be different from the manual, but it will not affect your normal use.

On S866 LCD display pannel of my Sheng milo Mx20plus, I surprised that long pressing key"-" when set P16 , It can change all P"s setting back to manufacturer"s. (I don"t know why not shown on their user manual)

How to use and program your electric bicycle display computer This is the instructions for a S866 LCD with P01 to P20 explained. The display is compatible wi...

I just bought an S866 LCD paired with a BrainPower 36/48v 350 Watt controller and had both the E10 and E30 errors and after 4 hours of diagnosing what was wrong i found 2 issues.

P07: Number of speed magnets: Range: 1-100; This parameter is related to the display speed of the meter and needs to be entered correctly. If it is a normal hub motor, directly input the number of magnetic steel; If it is a high speed motor, it is also necessary to calculate the reduction ratio, input data = number of magnets × reduction ratio; For example: motor magnet steel number 20, reduction ratio 4.3: input data: 86=20×4.3

P08: Speed limit: the range is 0-100km/h, 100 means unlimited speed. The input data here indicates the maximum running speed of the vehicle: for example, input 25, indicating that the maximum running speed of the vehicle does not exceed 25km/h; the driving speed is maintained at the set value. Error: ±1km/h; (both assist and speed limit) Note: The value here is based on kilometers. When the unit setting is converted from kilometer to mile, the speed value of the display interface will be automatically converted to the correct mileage value, but the speed limit value data set at this menu under the mile interface. No conversion, inconsistent with the actual display mile speed limit value;

I tried the S866 with my 1500W KT-36/48v before diagnosing so not sure if still getting the E10 because not sure what protocol the KT controller communicates on

in this post, I will share with you my personal experience of how to set up an ebike controller also I will share information about the most popular ways to set up your ebike controller using an LCD display screen.

As a general rule, all LCD screen for ebike has the same parameter “P & C” however, the meaning of the parameter can be different from a manufacturer to other.

This LCD has three main screens that give you different information about your ebike, also it has a screen for advanced options where you can set up your controller & ebike setting.

1- If you turn the screen on and directly hold the below button you will activate the walking mode where your ebike motor will start working automatically & you will see a person symbol on the screen.

Once you turn on your ebike LCD you will see the first screen information which shows you the battery levels, PAS (Pedal Assist System), speed reading, distance, motor temperature, and motor wattages. (see the below photo)

Ebike Trick:  the distance meter is a trip distance meter which you can be rest by holding the up & down button at the same time while you are on the main screen, once the screen starts to flash press the middle button to save the reset.

Note: this trick will reset the trip counter but the odometer will still count your ebike distance & there is no safe way to reset the whole ebike distance.

C10: The factory reset settings (this with the reset the whole settings to the factory reset) if you want to reset all the settings all you need to do is to choose Y and Save it.

I had listed three different models of ebike LCD screens so you can have a good idea of how to configure your ebike controller using the same methods mentioned in this post.