ebike s866 lcd display settings parameters brands

Note: The value here is based on kilometers. When the unit setting is converted from kilometers to miles, the speed value on the display interface will be automatically converted to the correct mile value, but the speed limit value data set in this menu under the mile interface No conversion, it is inconsistent with the actual displayed mile speed limit value;

Note: Due to the upgrade of the company"s products, the displayed content of the product you get may be different from the manual, but it will not affect your normal use.

in this post, I will share with you my personal experience of how to set up an ebike controller also I will share information about the most popular ways to set up your ebike controller using an LCD display screen.

As a general rule, all LCD screen for ebike has the same parameter “P & C” however, the meaning of the parameter can be different from a manufacturer to other.

This LCD has three main screens that give you different information about your ebike, also it has a screen for advanced options where you can set up your controller & ebike setting.

1- If you turn the screen on and directly hold the below button you will activate the walking mode where your ebike motor will start working automatically & you will see a person symbol on the screen.

Once you turn on your ebike LCD you will see the first screen information which shows you the battery levels, PAS (Pedal Assist System), speed reading, distance, motor temperature, and motor wattages. (see the below photo)

Ebike Trick:  the distance meter is a trip distance meter which you can be rest by holding the up & down button at the same time while you are on the main screen, once the screen starts to flash press the middle button to save the reset.

Note: this trick will reset the trip counter but the odometer will still count your ebike distance & there is no safe way to reset the whole ebike distance.

C10: The factory reset settings (this with the reset the whole settings to the factory reset) if you want to reset all the settings all you need to do is to choose Y and Save it.

I had listed three different models of ebike LCD screens so you can have a good idea of how to configure your ebike controller using the same methods mentioned in this post.

The issue I had was that although the battery was fully charged and had 37V the LCD display on the handlebar shows empty battery and the motor would not power when pedalled or using walk mode.

I have fitted the Brainpower controller (model S866-C) and the LCD display S886 (thinking good to fit a pair), the good news is this now shows full battery on the S866 display and when I use the walk mode the front wheel drives correctly at about 4 mph (after using the intelligent wire to reverse direction).