flx-2210 lcd panel supplier

Use a supplied antenna cable to connect the VHF/UHF signal to the LCD TV’s ANT. terminal (refer to page 15-18). Connect the AC power cord at the back of the TV and connect the power cord to wall outlet. Insert the 2 batteries supplied in remote control.

Connects to the audio jack on the digital/standard 5.1 audio system. VHF/UHF IN Connects RF input from VHF/UHF antenna or cable to receive high/standard defi nition television. Chapter 1 Introducing the LCD TV HDMI IN COAXIAL VIDEO IN S-VIDEO IN...

EXIT INFO MENU Eff ective range: The remote can control the LCD TV from up to 5m away, if pointed directly at the receiver. Chapter 2 Installing the LCD TV Pressing INPUT display the source list, INPUT use ▲▼ to select the video equipment...

A: Shows how to use a VHF/UHF combination outdoor antenna. B: Shows how to use a separate VHF and/or UHF outdoor antenna. A. Combination VHF/UHF antenna B. Separate VHF and/or UHF antennas Chapter 2 Installing the LCD TV VHF/UHF Antenna 300/75-ohm adapter...

Use a supplied antenna cable to connect the TV signal to the LCD TV’s TV CABLE terminal. VHF/UHF IN Connect the AC power cord at the back of the TV and connect the power cord to wall outlet. Press the button on the remote to turn on the LCD TV.

Chapter 2 Installing the LCD TV Press the button on the remote to turn on the LCD TV. Press the button on the remote to display the Input List. Use the ▲▼ buttons to select Input TV and press the OK button.

Controls the width of the picture based on the VGA mode ▪ Phase Controls the signal phase, which can improve focus clarity and image stability based on the VGA mode Chapter 3 Using the LCD TV User Select Back Select...

Select for surround sound (for stereo programs only) ▪ OFF: Select OFF to turn off the external audio system Allows to select the audio language: English/Spanish/French. Audio Language Allows to select to turn on or off the TV speakers. Speaker Chapter 3 Using the LCD TV...

Chapter 3 Using the LCD TV Channel Block Input Block Change Password Allows adjustment of the display’s gamma correction, which fi ne Gamma tunes both brightness and red/green/blue ratios: On/Off/Middle. Press the OK button to restore factory settings Reset Default Allows to block digital channels.

Chapter 3 Using the LCD TV Canadian English Ratings Canadian Englsh Ratings includes the following options: Allowed Rating Blocked Rating Canadian English Ratings Select Back RATING DESCRIPTION All children Children 8 years and older General programming Parental guidance Viewers 14 and older Adult programming ▲...

In addition, LCD Inverter takes DC-12 Volts from supply and starting signal pulse from main board, which fire the overall process in the inverter circuit. Switching is present, so as to start the controlled oscillation through inverter dimming controller IC chip. Which controls several functions.

A few days back I had opened up my iMac to replace the HDD with an SSD and while reassembling the iMac, I booted up the system only with the LCD in place without putting on the glass panel to make sure that the issue was not being caused by any dust stuck between the glass panel and the LCD but the spots were still there on the LCD display. So, the issue exists within the LCD panel itself. Also, I noticed some part of the black tape stuck on the backside of the LCD had yielded from the top (circled in red in the picture below).

As the insides of the iMac were extremely dirty with literally layers of black dirt as visible in the picture above, could this have caused dust to get inside the LCD panel causing the dark spots or is something else causing this problem?