uctronics 3.5 inch hdmi tft lcd display in stock

The UCTRONICS 3.5-Inch TFT LCD Touch Screen w/ Pen for Raspberry Pi is the same size as the standard Raspberry Pi model B/B+, and well mates with the Raspberry Pi boards. With its touch screen and split audio from the HDMI input, it is ideal for portable devices and multimedia projects, and it is a replacement for a heavy and bulky HDMI monitor, keyboard and mice.

Color:3.5 inch HDMI LCD Display with SD card The 3.5 inch touch screen is the same size as the standard Raspberry Pi model B/B+, and well mates with the Raspberry Pi boards. With its touch screen and split audio from the HDMI input, it is ideal for portable devices and multimedia projects, and it is a replacement for a heavy and bulky HDMI monitor, keyboard and mice. FeaturesTouch function support system: Raspbian. Display function support system: Raspbian, kali, ubuntu, Retropie, PiPlayer, windows10 etcLCD Display Resolution: 480 x 320 pixelsHDMI Input Resolution support: 480x320 ~ 1920x1280Dimension: 55.98 x 85.60 mmSupport plug and play, touch screen, game and videoAutomatic driver installation scriptHeat sinks will protect your motherboard from overheating.Package Including1pcs 3.5 inch HDMI touch screen1pcs touch pen1pcs 16GB SD card1pcs HDMI to HDMI converter3pcs heat sinksNote: 1. The raspberry pi shown in the picture is not included.2. Recommend resolution: 480 * 320, 800 * 480, 800 * 600. Those resolutions higher than 480*320 will be compressed to 480*320 in LCD display. When resolution is compressed, the screen display ratio might be changed accordingly.Too High resolution will cause module power consumption rises.3. Please use the SD card which is with pre-installed driver and system directly.4. For the Male to Female Ribbon GPIO Cable to connect Raspberry Pi and 3.5inch Touch Screen, check ASIN: B07D991KMR.

For what it"s worth, that /etc/X11/Xwrapper.config file might be created after you boot once into the Desktop (assuming that you install an HDMI display, mouse and keyboard locally on that Pi). And then—assuming that the file is created after one bootup—that sed command then should work as you might expect it to.

Compatible and Direct-connect with any revision of Raspberry Pi. (If you are using a Raspberry Pi Zero / Zero 2 W, an additional HDMI cable is required.)

5) Insert the TF card into the Raspberry Pi, power on the Raspberry Pi, and wait for more than 10 seconds to display normally. But the touch is abnormal at that time, and the touch needs to be calibrated as the following steps.

You can perform touch calibration by clicking the Raspberry Pi icon on the taskbar, selecting Preferences -> Calibrate Touchscreen, and following the displayed prompts.

4. After calibration, the following data will be displayed. If you want to save these touch values, you can replace the data in the red circle with the data in the corresponding position in 99-calibration.conf.

The UCTRONICS 3.5 Inch touch screen is the same size as the standard Raspberry Pi model B/B+, and well-mates with the Raspberry Pi boards. With a tiny size, vivid image, and responsive touchscreen, it is definitely ideal for portable devices and multimedia projects. It is a great replacement for a heavy and bulky HDMI monitor, keyboard, and mouse

Step1: Align the pin 1 of the edge connector between the LCD display and Raspberry pi board, connect the pin 1,2,3,4 then pin 19,20,21,22,23,24,25,26.

Attention: If you use this display without a Pi, the touch function is not available because the touch function of this display just supports the Raspbian system. Meanwhile, an extra HDMI cable also is required for the video transmission.