stm32 with ssd1963 tft display quotation

I am working on STM32F103ZT6 and with SSD1963. I have connected 480X272 and 320X240 LCD’s. I am initializing SSD1963 with the Init Commands on same pins as you use, but in GPIO mode & not in FSMC mode. The Clock Freq from Crystal is 8MHz and in STM32 acitvating PLL is made to 72MHz. So, Clk Freq for SSD1963 is 8MHz. Hope we should configure the PLL in SSD1963. So below is my Initialisation Sequence details.

ER-TFTM070-4V2.1 is the updated version of ER-TFTM070-4,that is 800x480 dots 7" color tft lcd module display with ssd1963 controller board,superior display quality,super wide viewing angle and easily controlled by MCU such as 8051, PIC, AVR, ARDUINO, and ARM .It can be used in any embedded systems,industrial device,security and hand-held equipment which requires display in high quality and colorful image.

It supports 6800, 8080 8-bit /9-bit/16-bit/18-bit/24-bit parallel interface.Built-in MicroSD card slot.It"s optional for resistive touch panel and controller XPT2046,capacitive touch panel and controller FT5206, font chip, flash chip and microsd card. We offer two types connection,one is pinheader and the another is ZIF connector with flat cable mounting on board by default and suggested.

Of course, we wouldn"t just leave you with a datasheet and a "good luck!".Here is the link for7" TFT capacitive touch shield with libraries,examples,schematic diagram for Arduino Due,Mega 2560 and Uno. For 8051 microcontroller user,we prepared the detailed tutorial such as interfacing, demo code and development kit at the bottom of this page.

ER-TFTM090-1 is 800x480 dots 9"color tft lcd module display with SSD1963 controller board,superior display quality,super wide viewing angle and easily controlled by MCU such as 8051(C51), PIC, AVR, ARDUINO, and ARM and Raspberry PI .It can be used in any embedded systems,industrial device,security and hand-held equipment which requires display in high quality and colorful image.Portrait mode is also available.

It supports 6800, 8080 8-bit /9-bit/16-bit/18-bit/24-bit parallel interface.Built-in MicroSD card slot.It"s optional capacitive touch panel with controller GT911 and resistive touch panel with controller XPT2046,font chip, flash chip and microsd card. We offer two connections,one is pin header and the another is ZIF connector with flat cable. Lanscape mode is also available..

Of course, we wouldn"t just leave you with a datasheet and a "good luck!".Here is the link for 9 TFT Touch Shield with Libraries, Examples.Schematic Diagram for Arduino Due,Mega 2560,Uno. For 8051 microcontroller user,we prepared the detailed tutorial such as interfacing, demo code and development kit at the bottom of this page.

After more testing, the screen has some very annoying and frustrating behavior. It seems the screen does not want to initialize upon uploading a new sketch. Through serial monitor printouts I can tell the sketch is working and the screen is sending and receiving the correct data, but the screen just doesn"t want to do anything. Sometimes, for whatever reason, after waiting a while and rebooting the esp32, the screen starts up fine and works perfectly. From that point on it will work every single time after. However, uploading a new sketch kills it, and even after waiting, some sketches never work at all. Clearly the screen works because some sketches work fine, but there is some weird bug and I do not know what is going on. Sketches with literally identical setup code don"t do the same thing. I have gotten some shorter (10 cm) wires and that did not change anything. I am ready to give up and try to find a new/different screen.