serial lcd module manufacturer

A wide variety of lcd display serial interface options are available to you, You can also choose from original manufacturer, odm lcd display serial interface,As well as from tft, ips, and standard.

ER-OLED0.83-1W is the graphic OLED display module made of 96x39 individual white OLED pixels,diagonal is only 0.83 inch.The controller ic SSD1306, communicates via 8080 4-bit/8-bit parallel and I2C/4-wire serial interface,thanks to controller"s built-in voltage generation,only a single 3.3V power supply is needed. Because the display makes its own light, no backlight is required. This reduces the power required to run the OLED and is why the display has such high contrast,extremely wide viewing angle and extremely operating temperature.The fpc is the soldering type,no need connector.Just solder the FPC on your PCB directly.

Newhaven 16x2 character Liquid Crystal Display shows characters with dark pixels on a bright yellow/green background when powered on. This transflective LCD Display is visible with ambient light or a backlight while offering a wide operating temperature range from -20 to 70 degrees Celsius. This NHD-0216K3Z-FL-GBW-V3 display has an optimal view of 6:00. This display operates at 5V supply voltage and is RoHS compliant.

This is the latest evolution of our serial LCD. Included on a single board is a 16x2 LCD and an embedded circuit based around a PIC 16F88 and others. The Serial LCD is a simple and cost effective solution for interfacing to Liquid Crystal Displays (LCDs) based on HD44780 controller. The module takes incoming 9600 bps TTL level signals and display those characters on the LCD screen. Only three wires +5V, GND and Signal are needed to interface to the LCD.

Features:Operational BackspaceSimple 3 pin Interface to control LCD from 9600 baudrate from any microcontrollerContrast adjustment PresetBacklight can be controlled from softwareFull control of LCD from serial dataAuto-wrapping of displayed dataIncoming buffer stores up to 80 charactersPulse width modulation of backlight allows direct control of backlight brightness and current consumptionAll surface mount design allows a backpack that is half the size of the originalFaster boot-up timeBoot-up display can be turned on/off via firmwareUser definable splash screenSpecifications:The serial LCD should only be powered by 5V DCHigher than 5.5V will cause damage to the LCDThe serial LCD uses 3mA Backlight turned off and ~60mA with the backlight activatedPin Diagram:Ground: Black+5V DC: BrownRX IN: Red